Kick Panel Speaker Wire Harness for Speaker Replacement in 2021+ Ford Broncos (Sold as a Pair)
Zero-splice install harness — clean, reversible wiring with no cut factory connectors.
SKU: Ten87-5602-Bronco4
Plug-in, by design.
A pair of plug-in speaker harnesses for replacing the factory front kick-panel speakers, one for the driver side and one for the passenger side. One end of each harness plugs into the factory speaker connector and the other connects to your new speaker, so the factory wiring is never cut. Select your vehicle at the top of the page to check that it fits.
Why use a plug harness
- Zero-splice. The factory kick-panel wiring stays intact, with no cuts and no butt connectors.
- Reversible. Unplug the harness and the factory speaker plugs straight back in.
Sold as a pair - one pair covers both front kick-panel speakers. Upgrading the dash tweeters, rear pods or center channel too? Those positions use a different, smaller connector and take a separate harness pair.
Full specifications
- Sold As
- Pair
- Adapter Type
- Plug harness
- Harnesses
- 2
- Position
- Kick panel
- Covers
- Left + right
- Install
- Plug-in
- Splicing
- None
- Reversible
- Yes
The rest of the route, in one cart.
One part from each DIY step that fits your vehicle. Open any of them to choose its options and add it to your cart without leaving this page.
20 ft of power + 20 ft of ground in 100% OFC Kicker wire, fused at the battery — 1/0, 4 or 8 gauge.
Owners of Ford, Mazda, and Lincoln vehicles upgrading factory 6.5-inch speakers to aftermarket drivers
2021+ Ford Bronco owners upgrading factory kick panel speakers to aftermarket 6.5-inch drivers
Owners of Ford, Lincoln, Mazda, and Mercury vehicles with factory 6x8-inch oval speakers upgrading to 6.5-inch round aftermarket drivers
Everything customers actually ask.
The questions we get most on wiring and harnesses - answered straight. Not sure if yours is here? Call, and a human answers.
One year, on everything we sell. Every item is covered for one year from delivery. If something fails in that first year, we make it right. Questions about a claim? Call us — a real person handles it with you.
How they hold up once they're installed.
Just what I needed, can’t find anywhere else. Plug and play. Now the Bronco sounds like it should with some upgraded 6 3/4 and baby 4”.
worked perfectly. Install was very clean and simple!
The picture is misleading. It does not come with the clips. It just comes with the connector and two white and two black wires and then you have to figure out what is positive and what is negative and add the Clips to it yourself
Only comment I would make is- if you show speaker wire with ends crimped on ,then I thought they were included. Not a problem though.
Looking at your kick panel wire harness for the 6G. Bronco and a bit confused on the options. I have a non B&O system but it does have a factory sub and amp. I'm not sure of the correct harness to purchase other than the 4 pin flat unit
The kick panel speaker harness and speaker adapter are identical for all of the Broncos. Only when adding a amplifier does the factory system matter.
Not sure what'll fit? Just call.
Tell us your vehicle and factory system - we'll confirm the right harness before you order.



