Are you looking for a well-engineered, great-performing enclosure that goes behind your rear seat in your F-Series? If so, you have come across the right solution. What makes this enclosure unique is that it allows full functionality of the rear seat, without touching your subwoofers when lifted in the upright position.
While you may think a larger subwoofer is better, you are half right. Larger subwoofers require larger enclosures if you want a high level of performance, without internal airspace, the low bass will fall on its face. Bigger is better, but what you mean to say, isBigger the Enclosure the better, not subwoofer size.
So how are we able to squeeze out so much performance from small-diameter drivers? It's a mix of science and experience. The main benefit of our enclosure is its vented (Ported) design, this allows higher efficiency over a traditional sealed enclosure. Think turbocharger on an engine, the displacement of the engine might be smaller, but horsepower goes up. This vent we can manipulate to work with the acoustics of the truck, whereas a sealed enclosure, you have very limited ways to "tune" the output.
As you might know, we work with an amazing brand JL Audio that makes some pretty amazing shallow subwoofers. So why do we not utilize those drivers in our enclosures? Simply put, the vented design of our enclosure delivers better performance in this exact application. The second part, is if you face a subwoofer forward, it will touch the seat and damage the subwoofer, nobody wants that.
Hand-Crafted Enclosure Details: - Pre-loaded with Two 6.5-inch Subwoofers in our vented enclosure, pre-wired - Premium Materials (Premium MDF, High-Grade Carpet) - The only enclosure that honestly fits behind the seat without damage to the subwoofers that still delivers a high level of performance - Hand-made by our Award Winning Team
Custom Made In-House Components: - Ten87 Design Custom Made Amplifier Rack - Vehicle Specific Plug and Play T-Harness - Full-length Power + Ground 8ga OFC Copper Wiring Kit - Subwoofer harness with quick disconnect connectors - Factory Subwoofer Block Off Plate
Additional Touches: - Tool Kit with helpful installation components - Pre-tuned and Tested In-House by the Sounds Good Stereo Team - Over-packaged to ensure safe arrival
Looking for an overview of the package? Here is a short 15-minute video that explains how this enclosure fits behind the seat and retains full functionality:
Check out the installation video below for a walk-through:
Installation requires slight modification to the rear carpet panel. The photo below shows the section that needs to be removed.
Clean solution to getting clean signal from factory bose system
Works exactly as listed. I got the one with rca's. For any that didnt read, these are low level signals and will Not turn on the signal sensing on some amps.
Very easy to install, only took me about 30 minutes from start to finish with basic tools. (there are videos of how to get to the amp on YT)
I bought this rack for the driver side just for my AC epic center. Had already bought the passenger side set up for my two AC altitude amps, 4 ch 600/4 and mono 1500/1. These are very true quality amp racks which requires no drilling or cutting to install. It bolts directly onto the floor with existing oem bolt or with provided screws from the box. Would 💯 recommend for anyone looking to properly stow away your amps!! Oh and the snacky little snacks was just the frosting on the cake 😉
Perfect fit! I opted to use a bead of silicone around the whole plate to seal and secure it. I didn't want to drill holes into the factory metal. Works perfectly.
The keyloc is a must for 2024 F250 with 8 speaker B&O system. Completely plug and play, works perfectly with a Kicker hideaway HS12 behind the rear seat. This setup provided the exact amount of low end fill I was looking for in the rear of the cab.
